PeterB 0 Report post Posted November 25, 2016 I was running WAPT Pro x64 4.0 from a batch file like this: D:\WAPT\WAPT_Pro_4_0\WAPTPro.exe -run D:\WAPT\Scenario\Performance.wps -noui >> D:\WAPT\temp\run.log This was working fine. After I upgraded today to Version 4.3, my batch doesn't run anymore. run.log only shows: WAPT Pro > WAPT Pro 4.3 (64-bit) Built on Oct 13 2016 WAPT Pro > Load settings from file: C:\ProgramData\Softlogica\WAPT\settings.xml With V4.0, the next message would be: WAPT Pro > Load scenario OK: D:\WAPT\Scenario\Performance.wps. But this doesn't happen. WAPT seems to stall here. When I remove "noui", then WAPT is started in UI mode and everything is working. Quote Share this post Link to post Share on other sites
sergei 0 Report post Posted November 28, 2016 Could you create a new scenario in WAPT Pro 4.3 and try to run it? Quote Share this post Link to post Share on other sites
PeterB 0 Report post Posted March 20, 2017 I've created a new scenario with WAPT Pro 4.3(Built Jan 25, 2017) and the issue is still there. It seems to be a problem with larger scenarios?!? My scenario has 4 profiles with over 800 requests each. Size per profile is between 8MB and 18MB. A smaller scenario with one profile and only 10 requests runs. Quote Share this post Link to post Share on other sites
